Application areas
The SE52H may be used for a wide variety of measure sensors:
-pressure sensors
-differential sensors
-load cells
-magnetic field sensors
-strain gauge
-resistor of 2/3/4 wires
The SE52H with HART-protocol is suitable for various sensors and converts input signals into 4~20mA analogue output signal. Standard installation of the SE52H is for 2088 and BP 800 housing. Further versions are possible on request. The SE52H can be programmed via three buttons.Following parameters can be adjusted: zero,span,decimal point,damping, display mode,restore data and so on. For parmenter setting and visualization of measured value an optional liquid crystal displays is available. The module is protected against miswiring and transient overvoltages.